Starrett - Slide Calipers

The Starrett No. 456 Gear Tooth Vernier Caliper is designed to measure in .001" or 0.02 mm the thickness of gear teeth at the pitch line (the chordal thickness of the teeth) using the distance from the top of a tooth to the chord. For the same purpose, it can also be used for measuring hobs, form and thread tools, etc.

The thickness of a tooth at the pitch line is measured by an adjustable jaw after the addendum is set by the adjustable tongue. Each of these is adjusted independently by screws on the graduated bars.

For Tool Operation:

a. Find on the chart, furnished with the tool, the number of teeth of the gear in question, and find the corrected addendum (s"). This figure is for one diametral pitch for inch measure, so divide it by the diametral pitch number – this figure is also for a one millimeter module for metric measure, so multiply it by the required module number. This gives a corrected addendum for this particular number of teeth.

b. Next, measure the actual outside diameter of the gear and add or subtract one-half the difference between the theoretical gear diameter and actual measured gear diameter from the corrected addendum (s") found in the first step.

c. Set the new calculated addendum figure on the adjustable tongue of the tool.

d. Now, with the tongue on the top of the tooth, measure the chordal thickness with the horizontal vernier jaw and compare with the figure in the "t" column in the chart.

e. All inch graduations are read to .001". However the No. 456A is graduated by .020" increments and the No. 456B is graduated by .025" increments. Nos. 456MA and 456MB are read to 0.02 mm and graduated by 0.5 mm increments.

Gear Tooth Vernier Calipers
No. 456 Series 20-2 Diametral Pitch
No.456M Series 1 1/4 - 25mm Module

J.W. Donchin Co.
Ph: 773-261-2182 • Fax: 773-261-2867 • Email: sales@jwdonchin.com